DX-GB8PRT_10-1124_QSG_V1.eps
1
10/299/2010
1:05::26 PM
V1
FINAL
FOR PRINT
Congratulations on your purchase of the DX-GB8PRT Dynex 8-Port
Gigabit Ethernet Switch. The DX-GB8PRT provides increased speed and
backbone connections to make Gigabyte a reality.
Installing the switch
1 Connect the power adapter to the switch and power outlet.
Power cord
Safety Notices
Power
• Do not use this product near water, for example, in a wet basement
or near a swimming pool.
Switch
outlet
• Avoid using this product during an electrical storm. There may be a
remote risk of electric shock from lightning.
• Do not place heavy objects on the switch.
• Allow room for adequate ventilation.
2 Connect the PC(s) and other device(s) to the switch.
DX-GB8PRT
8-Port Gigabit Ethernet Switch
Package contents
PC
Switch
Network
storage
•
•
DX-GB8PRT Dynex 8-Port Gigabit Ethernet Switch
Quick Setup Guide
3 Connect the switch to the Internet.
Features
•
Complies with IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.1p
standards
Internet
•
•
•
Eight 10/100/1000M RJ45 ports
Supports IEEE 802.1p QoS
Support Green Ethernet technology to implement power saving
features. (In Low Power Idle mode, up to 66.22% of the power can be
saved.)
Internet
Modem
Router
Switch
4 Install complete connection.
Internet
•
•
•
Supports IEEE 802.3x flow control for full-duplex mode and
backpressure for half-duplex mode
Non-blocking switching architecture that forwards and filters
packets at full wire-speed for maximum throughput
8K entry MAC address table of the DX-GB8PRT with auto-learning
and auto-aging
Network
storage
Switch
Router
PC
Modem
•
•
Supports for Jumbo frames of up to 15 KB
LED indicators for monitoring power, link, and activity
LED indicators
When the switch is plugged in and receiving power, the LED indicators
respond as follows:
Components
Front panel
LED
Status
Indication
Power
On (green)
Off
Power on
No device is connected to the corresponding port.
A 10/100 Mbps device is connected to the corresponding port.
On (orange)
Link/Act Flashing (orange) A 10/100 Mbps device is transmitting or receiving data
Ports 1-8
through the corresponding port.
Power LED
LEDs 1-8
Back panel
A 1000Mbps device is connected to the corresponding port.
On (green)
A 1000Mbps device is transmitting or receiving data through
the corresponding port.
Flashing (green)
Power port
Ports 1-8
QUICK SETUP GUIDE
|